HP LC2000r - NetServer - 128 MB RAM Administrator's Manual page 57

Chapter 5
If you are using an HP-UX workstation as a remote client, see the section
"Connecting to Integrated RA from an HP-UX Workstation," later in this
chapter.
The remote client display will more closely resemble the actual server display if
you use a PC-based color ANSI terminal emulator that supports 25 lines and the
PC character set. The tables below provide the terminal settings and parameters
you should configure for using the Integrated RA.
Table 5-1. Terminal Emulation Settings
Setting
Emulation
Character Set
Screen Dimensions
Line Wrap
Local Echo
Scroll
Carriage Return
Translation
Backspace Translation
Cursor
Table 5-2. Direct Connection Communications Parameters
Parameter
Baud Rate
Data Bits
Stop Bits
Parity
Handshaking
Connect
Disconnect
Keyboard Mapping
If you are using a terminal emulator other than pcAnywhere, or a direct connection
to a terminal, you need to emulate the functions of special server keyboard keys
(for example, ESC, Home, and so on) via the terminal emulator. This emulation
can be accomplished by the mapping of ANSI escape sequences to the special
keys. Most terminal emulators permit the remapping of special keys to character
Recommended Alternate
ANSI Color Monochrome ANSI/VT-100
Extended PC/IBM PC ANSI
80 x 25 80 x 24
OFF
OFF
ON
None
None
Underline, blinking
Recommended Alternate
38,400 See Configuration Utility
8
1
None
None
Assert DCD
Drop DTR
Setting Up the Remote Client
53