Configuring Integrated Ra; Checking Server Bios Communications Parameters - HP LC2000r - NetServer - 128 MB RAM Administrator's Manual

Chapter 3

Configuring Integrated RA

During the initial server setup, you run the Integrated RA Configuration Utility to
configure server management operations including:
Verify Management Port settings
Set up an administrator list for system access and pager notification
Configure event management operations, including the enabling of paging
Test Integrated RA functions
Configure communications for the external modem or direct serial
connection
Specify a server keyboard layout
Re-arm monitors
Specify a server name and identification number to be included with
notification pages
NOTE
Many of the configuration tasks that you can perform with the
Configuration Utility on the server can also be duplicated via
the Integrated RA Management Program that you run from the
remote client. See Chapter 6 for details.

Checking Server BIOS Communications Parameters

Before configuring the server's Integrated RA features, you need to make sure that
the server's Management Port is properly set for remote connections.
To check and, if necessary, reconfigure the server's Management Port parameters:
1. Boot the server and when prompted during bootup, press [F2].
The server opens the BIOS Configuration Utility.
2. From the BIOS Configuration Utility main menu go to Configuration }
Integrated IO Ports | Serial Ports.
The BIOS Configuration Utility displays all serial port parameters.
3. Verify that the Management Port parameters are set as follows:
Integrated RA Setup and Configuration
19