Function List - Brother S-7200B Service Manual

3-5. Function List

Function No. 0 − 15
No. Initial value
0 0 (degrees)
1 0 (degrees)
2 0
3 1
4 0
5 0
6 0
7 0
9 0
11
0
(NOTE 1)
12 0
13 0
14 0
15 0
(NOTE 1) If function No. 69 is set to "3", operation is enabled.
(NOTE 2) Presser foot will not drop if DIP switch 1 is set to OFF.
*... Enabled if the control box model is MD-741A/751A.
(Alternating): The presser foot is raised or lowered each time the optional actuator is pressed.
(Momentary): The presser foot is raised only while the optional actuator is being pressed.
Setting range
Needle up stop position setting
-10 – 20
(degrees)
Needle down stop position setting
-10 – 10
(degrees)
Depressing forward when depressed backward (thread trimming)
0 – 1 0: Disabled (depressing forward is enabled after returning to neutral position)
1: Enabled
Power supply voltage drop check (reset detection) function
0 – 1 0: Not used
1: Used; "Err 6" is displayed when a voltage drop occurs
Buzzer (electronic sound) for panel operation
0 – 1 0: Used
1: Not used
– (Do not change this setting.)
Needle penetration up operation
0 – 1 0: Used
1: Not used
Backtack sewing speed
0 – 1 0: Limited by sewing speed control key
1: Not limited by sewing speed control key
End backtack sewing speed
0 – 1 0: Separate setting from start backtack sewing speed is possible
1: Setting for start backtack sewing is used
Option actuator operation setting
0: Half stitch correction sewing
1: Single stitch correction sewing
2: Single reverse stitch correction sewing (reverse feed)
0 – 4
3: Thread trimming
4: Single end backtack cycle cancel
5: Solenoid-type presser foot lifter is raised (Alternating*)
6: Solenoid-type presser foot lifter is raised (Momentary*)
Presser foot status when treadle is returned to neutral after thread trimming
0 – 1
0: Presser foot drops (See NOTE 2)
1: Presser foot does not drop
Presser foot status after treadle stops at neutral
0 – 1 0: Presser foot does not lift
1: Presser foot lifts
Actuator function
0: Reverse stitch switch during operation, correction sewing switch when
0 – 1
stopped
1: Thread trimming switch
Slow stop control when treadle is returned to neutral
0 – 1 0: Slow stop control without step operation
1: Above control is not used
3. FUNCTION SETTINGS (OPERATION PANEL)
Setting details
Becomes higher
Becomes lower
S-7200B
Becomes lower
Becomes higher
2243M
2244M
6