Brother S-7200B Service Manual page 25

Function No. 108 − 114
No. Initial value
108
0 (needles)
(NOTE 30)
109
10 (ms)
(NOTE 31)
110
0 (ms)
(NOTE 31)
111
0 (ms)
(NOTE 32)
112
2000 (ms)
(NOTE 33)
113
0 (needles)
(NOTE 34)
114
0 (needles)
(NOTE 34)
(NOTE 30) Setting is enabled when Function No. 70 is set to "2".
(NOTE 31) Setting is enabled when Function No. 70 is set to "4".
(NOTE 32) Setting is enabled when Function No. 70 is set to "5".
(NOTE 33) Setting is enabled when Function No. 70 is set to "2" or "5".
(NOTE 34) The stitch number control output signal can be set in accordance with the variable input signal.
<Stitch number control output signal>
The variable input signal should be connected to connector CN6. The output signal is sent to connector CN11.
Motor
Needle up signal
Variable input signal
Output signal
NOTE: If Function No. 112 and No. 113 are set to "0", output is synchronized with the variable input signal.
Setting range
0 – 99
Number of stitches for option output (C1)
(needles)
0 – 990 (ms) Delay time until option output turns on (C2)
0 – 990 (ms) Option output on time (C3)
0 – 990 (ms) Delay time until option output turns on (C4)
0 – 9900 (ms) Option output on time (C5)
0 – 99
Number of stitches for option output (C6)
(needles)
0 – 99
Number of stitches for option output (C7)
(needles)
External input
External output; signal is open collector output within maximum 10 mA
3. FUNCTION SETTINGS (OPERATION PANEL)
Setting details
S-7200B
2262M
2263M
18