Adjusting Arm Thread Guide R; Adjusting The Presser Foot Height - Brother S-7200B Service Manual

Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs

Advertisement

Table of Contents
6. ADJUSTMENTS

6-4. Adjusting arm thread guide R

Becomes greater

6-5. Adjusting the presser foot height

27
Becomes less
3695M
2278M
S-7200B
The standard position of arm thread guide R (1) is the
position where the screw (2) is in the center of the adjustable
range for arm thread guide R (1).
* To adjust the position, loosen the screw (2) and then
move arm thread guide R (1).
・ When sewing thick material, move arm thread guide R
(1) to the left. (The thread take-up amount will become
greater.)
・ When sewing thin material, move arm thread guide R
(1) to the right. (The thread take-up amount will
become less.)
The standard height of the presser foot (1) is 6 mm when the
presser foot (1) is raised by means of the lifting lever (2).
1. Loosen the nut (3) of the adjustment screw (4), and then
turn the adjustment screw (4) so that there is no pressure
applied to the presser foot.
2. Raise the lifting lever (2). The presser foot (1) will also
rise.
3. Remove the oil cap (5).
4. Loosen the bolt (6) and then move the presser bar (7) up
or down until the presser foot (1) is at the standard height
of 6 mm.
5. Tighten the bolt (6).
6. Replace the oil cap (5).
7. Adjust the presser foot pressure using the adjustment
screw (4), and then tighten the nut (3).

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Brother S-7200B

This manual is also suitable for:

Md-741bMd-751bMd-741cMd-751c

Table of Contents