Setting The Needle Up Stop Position And Needle Down Stop Position (If Using The Control Box Panel) - Brother S-7200B Service Manual

6. ADJUSTMENTS
6-14. Setting the needle up stop position and needle down stop position
(If using the control box panel)
Meaning of displays during setting
•
The stop position is set numerically, and "A" to "F"
represent the numbers "10" to "15" respectively.
•
A setting value of "8" corresponds to an angle of
rotation of approximately 8° for the upper shaft.
<Before setting>
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
1
2
35
Display
Value
DANGER
Set DIP switch -3 to OFF.
(This will cancel the lock so that the functions can be set.)
Control box
While pressing the end backtack key (1), press the power
switch (2) to turn on the power.
S-7200B
A b c
10 11 12
d E F
13 14 15
3143M
0706B