Control Box And Motor; Removing And Installing The Control Box - Brother S-7200B Service Manual

10. CONTROL BOX AND MOTOR

10. CONTROL BOX AND MOTOR

10-1. Removing and installing the control box

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
49
DANGER
<Removal>
1. Remove the cable tie (1) and the shielded wire clips (2)
and (3) in that order, and then disconnect all of the
connectors (4) to (7) from the sewing machine.
* Be careful not to break the pawls of connectors (5), (6)
and (7).
0656B
2. Disconnect the power supply connector (8) and the motor
connector (9).
3. Disconnect the ground wire (10).
2322M
4. Loosen the nuts (11) and (12) (without removing them).
5. Remove the bolt (13) and nut (14).
2323M
6. Pivot the control box around the bolt (15) and pull it out to
remove it from the table.
<Installation>
Install by following the removal procedure in reverse.
2324M
S-7200B