Standing Operation Pedal; Installing The Foot Plug - Brother S-7200B Service Manual
Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs
Also See for S-7200B:
- Parts manual (85 pages) ,
- Instruction manual (74 pages) ,
- Manual de instrucciones (74 pages)
Table of Contents
Advertisement
12. STANDING OPERATION PEDAL
The foot plug assembly CDD (J04099-001) that is sold separately is required.
12-1. Installing the foot plug
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
1.
Connect the foot plug (1) to connector CN3 on the control circuit board.
2.
Connect the standing pedal connector (2) to the foot plug (1).
3.
Secure the cord (3) of the standing pedal with the shielded wire clip (5) and the cable tie (4).
DANGER
S-7200B
12. STANDING OPERATION PEDAL
0703B
62
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the S-7200B and is the answer not in the manual?
Questions and answers