Verifying The Initial Configuration; Completing The Configuration - Cisco 2811 - Voice Security Bundle Router Hardware Manual

Verifying the Initial Configuration

Verify that the new interfaces are operating correctly by performing the following tests:
•
•
•
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. See the
locating documentation for advanced configuration procedures.

Completing the Configuration

When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. For advanced configuration procedures, use either SDM or the CLI.
For configuration procedures using SDM, refer to the
Quick Start Guide
For configuration procedures using the CLI, refer to the online
documents. The software configuration documents include information about the following topics:
•
•
•
•
•
OL-5788-01
To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter the show interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
that shipped with your router.
Basic software configuration
Feature documentation
Configuration examples
Troubleshooting and maintenance
Cisco 2800 series cards and modules
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
"Completing the Configuration" section on page 9
Cisco Router and Security Device Manager (SDM)
Configuring the Router
for information about
Cisco 2800 series software configuration
9