Cisco 2811 - Voice Security Bundle Router Hardware Manual page 150

Installing and Removing AIMs
Figure 22
Install the two metal standoffs (included in the accessory kit) in place of the two screws that are labeled
Step 3
A in Figure
Caution Make sure that the standoffs are straight when installed. Tighten them gently but firmly. The shoulder
must be seated tight against the system board.
Install the plastic standoff (included in the accessory kit) in place of the screw that is labeled B in
Step 4
Figure
shoulder must be seated tight against the system board. (See
Note
Plug the AIM into the AIM connector on the system board. (See
Step 5
standoff fits into the hole in the AIM board and that the connector is fully seated.
Insert the screws (included in the accessory kit) through the AIM into the metal standoffs. (See
Step 6
Figure
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
22
Removing Screws from System Board—AIM Slot 1 Installation Shown
A
System board
22. Use a 1/4-inch nut driver to tighten the standoffs. (See
22. Tighten it firmly with your fingers, or very carefully using a 3/16-inch open-end wrench. The
The Cisco 2801 router does not have a screw in the spot labeled B in
a hole in the system board in approximately the same location. Insert the plastic standoff in the
hole in the system board on Cisco 2801 routers.
23.) Tighten the screws carefully with a Phillips screwdriver.
A
B
B
A
AIM slot 0
connector
Figure
Figure
A
AIM slot 1
connector
Figure 23.)
23.)
Figure 22. Instead, there is
23.) Make sure that the plastic
OL-5792-04