Cisco 2811 - Voice Security Bundle Router Hardware Manual page 143

Figure 15
1
Firmly press the DIMM into the socket until the spring-loaded clips on the socket snap over the end of
Step 4
the DIMM.
Installing a DRAM DIMM in a Cisco 2811, Cisco 2821, or Cisco 2851 Router
To install a DRAM DIMM in a Cisco 2811, Cisco 2821, or Cisco 2851 router, follow these steps:
Locate the DRAM DIMM connector on the system board. See
Step 1
Figure
Make sure that both latches on the DIMM connector are in the open position.
Step 2
Orient the DIMM so that the polarization notch lines up with the polarization key on the connector. See
Step 3
Figure
Insert the DIMM carefully into the connector.
Step 4
Carefully and firmly press the DRAM DIMM into the connector until the latches close onto the DIMM.
Step 5
Make sure that both latches rotate to the closed position against the DIMM. See
OL-5792-04
Installing a DIMM
1
DIMM
11, depending on your router model, for the location of the DIMM connectors.
12.
2
2
Insert and rotate into socket.
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
Installing and Removing DRAM DIMMs
Figure 8, Figure 9, Figure
Figure 16.
10, or
15