Verifying The Initial Configuration; Initial Configuration Of The Wireless Access Point - Cisco 860 Series Hardware Installation Manual

Chapter 4 Initial Configuration
snmp-server community public
!
no ip routing
!
interface FastEthernet0
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Respond to the following prompts. Enter 2 to save the initial configuration.
Step 12
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Verify the initial configuration. See the
Step 13
verification procedures.
After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional
configuration.

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, perform the following tests:
•
•
•
After you complete and verify the initial configuration, you can configure your Cisco router for specific
functions.

Initial Configuration of the Wireless Access Point

The embedded wireless access point (AP) runs its own IOS. You can initially configure the embedded
wireless AP using one of the following methods:
•
•
OL-16193-01
To verify that the interfaces and line protocol are in the correct state—up or down—enter the show
interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
Cisco Configuration Professional (CP) Express
Setup command facility on the embedded wireless device
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
"Verifying the Initial Configuration" section on page 4-5
Verifying the Initial Configuration
for
4-5