Applying The Aim Label - Cisco 2811 - Voice Security Bundle Router Hardware Manual

Introduction and warnings
Hide thumbs Also See for 2811 - Voice Security Bundle Router:
Table of Contents

Advertisement

Installing and Removing AIMs
Figure 26

Applying the AIM Label

The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on
the AIM card. Apply the chassis label as follows:
Step 1
If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the
perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.
Step 2
Peel the chassis label from its backing.
If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is
Step 3
available on the back of the chassis, apply the label to the top cover at the back edge. The label must be
visible with the chassis installed. See
Note
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
26
CompactFlash Memory Card Installation on the AIM
Do not apply the AIM label to a blank cover plate; to any removable network module or interface
card; or over any holes, screws, or existing labels.
Figure 27
for a typical label location on the back of a chassis.
OL-5792-04

Advertisement

Table of Contents
loading

This manual is also suitable for:

2800 series

Table of Contents