Cisco 2811 - Voice Security Bundle Router Hardware Manual page 180

Installing the Chassis Cover
Installing the Cover on Cisco 2811 Routers
To install the chassis cover on a Cisco 2811 router, follow these steps. A number 2 Phillips screwdriver
is required.
Position the cover so that it rests flat on the chassis, with the front (bezel) end of the cover about 1 inch
Step 1
(25 mm) from the front end of the chassis. See
Figure 51
Chassis
Cover
Step 2 Slide the cover toward the front so that the fingers enter the slots and the cover is fully closed. Press the
cover flat against the chassis while you slide the cover closed.
Use a Phillips' screwdriver to install the four screws at the top rear of the cover.
Step 3
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
52
Cover in Position for Installation
Figure 51.
Plastic bezel
Approx. 1 inch
(25 mm)
OL-5792-04