Verifying The Initial Configuration - Cisco 4451-X Hardware Installation Manual

Chapter 4 Initial Configuration
64241 Oct 09 2012 20:47:59 +00:00
/bootflash/tracelogs/fman-fp_F0-0.log.12268.20121009204757.gz 43 177 Oct 11 2012 19:27:03
+00:00 /bootflash/tracelogs/inst_compmatrix_R0-0.log.gz 44 307 Oct 11 2012 18:24:41 +00:00
/bootflash/tracelogs/inst_cleanup_R0-0.log.0000.20121011182441.gz 45 309 Oct 11 2012
18:29:42 +00:00 /bootflash/tracelogs/inst_cleanup_R0-0.log.0000.20121011182942.gz 46 43748
Oct 06 2012 13:49:19 +00:00 /bootflash/tracelogs/hman_R0-0.log.0498.20121006134919.gz 47
309 Oct 11 2012 18:44:43 +00:00
/bootflash/tracelogs/inst_cleanup_R0-0.log.0000.20121011184443.gz 48 309 Oct 11 2012
19:04:46 +00:00 /bootflash/tracelogs/inst_cleanup_R0-0.log.0000.20121011190446.gz 49 2729
Oct 09 2012 21:21:49 +00:00 /bootflash/tracelogs/IOSRP_R0-0.log.20011.20121009212149 50
116 Oct 08 2012 21:06:44 +00:00
/bootflash/tracelogs/binos_log_R0-0.log.20013.20121008210644
Note

Verifying the Initial Configuration

Enter the following commands in the Cisco IOS-XE to verify the initial configuration on the router:
•
•
•
•
•
When you have completed and verified the initial configuration, the specific features and functions are
ready to be configured. See the
Router
OL-27644-01
To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to
NVRAM.
show version—Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and
flash memory.
show diag—Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters.
show interfaces— Shows interfaces are operating correctly and that the interfaces and line protocol
are in the correct state—up or down
show ip interface brief— Displays a summary status of the interfaces configured for IP protocol.
show configuration— Verify that you have configured the correct hostname and password.
Software Configuration Guide for the Cisco 4451-X Integrated Services
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
Verifying the Initial Configuration
4-23