Cisco 2811 - Voice Security Bundle Router Hardware Manual page 116

Installing and Removing Filler Panels in Network Module Slots
Installing and Removing Filler Panels in Network Module Slots
You can install filler panels in extended-wide network module slots to reduce the slot width. Use one
filler panel to reduce an extended single-wide slot (NME-X) to standard single-wide (NME). Use two
filler panels to reduce an extended double-wide slot (NME-XD) to standard double-wide (NMD).
Figure 5
Figure 5
You can use filler panels in the following configurations:
•
•
Installing Network Modules in Cisco 2800 Series Routers
4
shows a filler panel for network module slots.
Filler Panel for Network Module Slots
In a Cisco 2821 router, use one filler panel to reduce the extended single-wide slot (NME-X) to
standard single-wide slot (NME).
In a Cisco 2851 router, use filler panels as follows:
To create a slot for a standard double-wide network module (NMD), use two filler panels at the
–
far right. See Figure 6.
To create a slot for an extended single-wide network module (NME-X), use one filler panel at
–
the far right, a slot divider in the middle, and a blank panel at the right. See
To create a slot for a standard single-wide network module (NME or NM), use one filler panel
–
at the far right, a slot divider in the middle, a blank panel at the right, and a filler panel next to
the slot divider. See Figure 8.
Figure 7.
OL-5790-01