Verifying The Initial Configuration - Cisco 2900 series Installation Manual

Verifying the Initial Configuration

Router# show {flash0|flash1}:
System flash directory:
File Length Name/status
1 4137888 c3900-c2is-mz
[4137952 bytes used, 12639264 available, 16777216 total]
16384K bytes of processor board System flash (Read/Write)\
Router# copy {flash0|flash1}: tftp:
IP address of remote host [255.255.255.255]? 172.16.13.110
filename to write on tftp host? c3900-c2is-mz
writing c3900-c2is-mz !!!!...
successful ftp write.
Note
Verifying the Initial Configuration
Enter the following commands in the Cisco IOS to verify the initial configuration on the router:
•
•
•
•
•
When you have completed and verified the initial configuration, the specific features and functions are
ready to be configured. See the Cisco 1900 Series, 2900 Series, and 3900 Series Software Configuration
Guide.
If you need help with the interface and port numbering, see the
Note
section on page
Cisco 2900 and 3900 Series Hardware Installation
4-24
To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to
NVRAM.
show version—Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and
flash memory.
show diag—Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters.
show interfaces— Shows interfaces are operating correctly and that the interfaces and line protocol
are in the correct state—up or down
show ip interface brief— Displays a summary status of the interfaces configured for IP protocol.
show configuration— Verify that you have configured the correct hostname and password.
1-28.
Chapter 4 Configuring the Router
"Slot, Port, and Interface Information"
OL-18712-01