Cisco 2811 - Voice Security Bundle Router Hardware Manual page 148

Installing and Removing AIMs
Install the two machine-thread metal standoffs into the system board in the metal standoff attachment
Step 3
locations, as shown in
standoffs are denoted by a star pattern around the standoff mounting holes.
Caution Make sure that the standoffs are straight when installed. Tighten them gently but firmly. The shoulder
must be seated tightly against the system board.
Insert the plastic standoff with a snap fit on the ends (see
Step 4
in the system board. See
locked to the board.
Note
Figure 20
AIM end
Locking end
Insert the connector on the AIM into the AIM connector on the system board. See
Step 5
Note
Insert the screws from the accessory kit through the AIM into the metal standoffs. See
Step 6
Carefully tighten the screws with a Phillips screwdriver.
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
20
Figure 18. Use a 1/4-inch nut driver to tighten the standoffs. Locations for AIM
Figure 18. Press the standoff firmly into the system board to be sure that it is
The plastic standoff snaps into the system board. Be sure to insert the locking end of the standoff
into the system board. The locking end is the shortest end of the standoff.
the locking end of the plastic standoff used with compression AIMs.
Plastic Standoff Orientation
Be sure to press firmly on the AIM until the board seats onto the connector. The plastic standoff
must snap into the hole in the AIM board. See
Figure 20) from the accessory kit into the hole
Figure 18.
Figure 20 identifies
Figure 18.
Figure 18.
OL-5792-04