Cisco 2811 - Voice Security Bundle Router Hardware Manual page 62

Installing Internal Field-Replaceable Units (FRUs)
Figure 4 Chassis Slot Locations in Cisco 2851 Routers
2
1
H
W
A= ACT A= FDX
I
S= SPEED A= LINK C
3
GE 0/0
GE 0/1
A A
F F
H
S S
W
I
L L
C
1
PVDM2 PVDM1 PVDM0 AIM1 AIM0
1
1 Gigabit Ethernet port 0/0
2 Gigabit Ethernet port 0/1
3 High-speed WAN interface card slot 0
4
High-speed WAN interface card slot 1
5 High-speed WAN interface card slot 2
1. The network module slot is compatible with Cisco network modules of type NM (network module), NME (network module enhanced), NME-X
(enhanced extended), NMD (double-wide), and NME-XD (enhanced extended double-wide).
Installing Internal Field-Replaceable Units (FRUs)
Cisco routers are shipped with default memory and power supplies already installed, and usually
configured and shipped with interface cards, network module cards, packet voice data modules
(PVDMs) and advanced integration modules (AIMs). If you need to remove or install any of the internal
items, see the following product installation documents:
For AIMs
•
For PVDMs
•
For Internal Power Supplies
•
For Installing DRAM, SDRAM, or NVRAM
•
Chassis Installation Procedures for Cisco 2800 Series Routers
4
6 4
5
8
The "Installing and Removing AIMs"
Cisco 2800 Series Routers
The "Installing and Removing PVDMs"
in Cisco 2800 Series Routers
The "Replacing the Power Supply"
Cisco 2800 Series Routers
The "Installing and Removing DRAM DIMMs"
Modules in Cisco 2800 Series Routers
3
H
W
I
C
2
H
W
I
C
0
6 High-speed WAN interface card slot 3
7 Extension voice module slot
8 Network module enhanced (NME) slot
9
Screw holes for ground lug
section of the Installing and Upgrading Internal Modules in
online document
section of the
online document
section of the Installing and Upgrading Internal Modules in
online document
section of the
online document
7
1
Installing and Upgrading Internal Modules
Installing and Upgrading Internal
EVM 2 ONLY
9
OL-5786-03