Cisco 2811 - Voice Security Bundle Router Hardware Manual page 83

Connecting Routers to Backup Power
If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco Redundant Power
System Hardware Installation Guide for instructions about the power connections. You can access this
document at:
http://www.cisco.com/univercd/cc/td/doc/product/access/rpsbk/rpshim/index.htm.
Caution Before connecting the RPS to the router, make sure that either the RPS is in standby mode or the RPS
AC power is disconnected. Connecting the RPS to AC power automatically places the RPS in active
mode.
Note The Cisco 2801 router does not support an RPS.
Connecting WAN, LAN, and Voice Cables
This section describes how to connect the WAN, LAN, and voice interface cables. It covers the following
topics:
•
•
One or two Ethernet cables are typically provided with the router. Additional cables and transceivers can
Note
be ordered from Cisco. For ordering information, contact customer service. For cable pinouts, refer to
the
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF
or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables,
detach the end away from the unit first. Statement 1026
OL-5787-02
Ports and Cabling, page 10
Connection Procedures and Precautions, page 12
Cisco Modular Access Router Cable Specifications
Connecting WAN, LAN, and Voice Cables
document.
Cable Connection Procedures for Cisco 2800 Series Routers
9