Verifying The Initial Configuration; Powering Off The Cisco Asr 1001-X Router Safely - Cisco ASR 1001-X Installation Manual

Verifying the Initial Configuration

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
copy running-config startup-config
Example:
Router# copy running-config startup-config
To aid file recovery and minimize downtime in case of file corruption, we recommend that you save
Note
backup copies of the startup configuration file and the Cisco IOS-XE software system image file on a
server.
Note To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to NVRAM.

Verifying the Initial Configuration

Enter the following commands in Cisco IOS-XE to verify the initial configuration on the router:
•
•
•
•
•
After you have completed and verified the initial configuration, the specific features and functions are
ready to be configured. See the
Configuration

Powering Off the Cisco ASR 1001-X Router Safely

This section explains how to shut down the Cisco ASR 1001-X Router. We recommend that before
turning off all power to the chassis, you issue the reload command. This ensures that the operating
system cleans up all the file systems.
Cisco ASR 1001-X Router Hardware Installation Guide
5-14
show version—Displays the system hardware version, the installed software version, the names and
sources of configuration files, the boot images, and the amount of installed DRAM, NVRAM, and
flash memory.
show diag—Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters.
show interfaces— Shows if interfaces are operating correctly and if interfaces and line protocols
are in the correct state, either up or down
show ip interface brief—Displays a summary of the interfaces configured for IP protocol.
show configuration—Helps verify if you have configured the correct hostname and password.
Guide.
Chapter 5 Cisco ASR 1001-X Router Power Up and Initial Configuration
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Saves the running configuration to the startup
configuration.
Cisco ASR 1000 Series Aggregation Services Routers Software
OL-32376-02