Install Bezel Nameplate And Labels; Replace Netserver Covers - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 4

Install Bezel Nameplate and Labels

1. Locate the appropriate nameplate for your NetServer's bezel.
2. Remove the old nameplate from your NetServer's bezel using a
needle nose pliers.
3. Secure the new LH 6000 (or LH 6000r) nameplate to the bezel as follows:
For the pedestal version (LH 6000), locate the short nameplate shipped
with this upgrade kit and snap it into place.
For a NetServer mounted in an HP systems rack, locate the long, thick
nameplate. Bend the nameplate slightly and insert the tabs at either end
of the nameplate into the slots in the bezel. Snap the nameplate into
place.
For a NetServer mounted in a Compaq rack, locate the long, thin
nameplate. Insert the snap at one end of the nameplate, and then insert
the other snaps successively.
4. Locate the "UPGRADED TO LH 6000" label shipped with this upgrade
kit.
5. Apply the label just below the serial number on the back of the chassis.

Replace NetServer Covers

1. Remove the old LH 3000/3000r Technical Reference Card from the pouch
inside the chassis, and replace it with the new LH 6000/6000r Technical
Reference Card.
2. Replace the NetServer covers.
3. If you have an HP NetServer LH 6000r in the rack orientation, slide the
NetServer back into the rack chassis and secure it to the rack.
4. Install the additional power cord shipped with the Power Supply Upgrade
Kit. This power cord connects to the cage that holds power supplies
3 and 4.
NOTE The NetServer LH 6000/6000r will not power on unless you
have three power supplies and two power cords.
5. Replace all power, telephone, and I/O cables you disconnected earlier.
Installing LH 6000/6000r Components
31