HP D7171A - NetServer - LPr Upgrade Manual page 30

Chapter 4
Figure 4-8. Install Additional VRMs if You Have Installed
a. Identify the VRM socket(s) where you must install VRMs. Two VRMs
have been preinstalled. All VRMs must be installed in ascending slot
order as indicated in Figure 4-5.
b. Open the VRM retaining latch.
c. Orient the VRM as shown in Figure 4-8 and press the VRM into the
socket until it is seated completely. The retaining latches close
automatically when the VRM is installed correctly.
CAUTION
When installing the new VRM, push only on the edge of the
main VRM board. Do not push on the large flat surface (if
your VRM has one) or any components on the board. Pushing
on any part of the VRM except the edge of the main board
may result in damage to the VRM.
d. Verify that the VRM is installed completely in the socket and the
retaining latches at the ends of the sockets are closed.
9. Check that your configuration switches are set correctly for your
processors. See the Technical Reference Card for the HP NetServer
LH 6000/6000r.
26
Installing LH 6000/6000r Components
More Than Two Processor Modules