Run The Basic System Test - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 5
7. Click Exit and press Enter to exit HP NetServer Navigator and restart the
NetServer.
If the NetServer does not restart, turn off the NetServer power, wait 10
seconds, and turn on power again.
NOTE
HP DiagTools Diskette #1 contains a
notes. View the
information about DiagTools.

Run the Basic System Test

Running the Basic System Test has two parts:
l
In Configuration Detection, DiagTools identifies all installed components.
l
The Basic System Test gives pass/fail results on each detected component.
To run the Basic System Test:
1. Insert HP DiagTools Diskette #1 and restart the NetServer if you haven't
done so already.
The Welcome screen appears.
2. Press F2 and follow the instructions on the screen to begin Configuration
Detection.
HP DiagTools scans the NetServer and identifies all installed components,
such as processors, memory, and SCSI devices.
3. Scroll through the list of detected components, and make note of any items
that were not detected. HP DiagTools cannot test components it has not
detected.
NOTE HP DiagTools does not list the CD-ROM drive on the
Configuration Detection screen, but it shows up in the Support
Ticket and can be tested using the Advanced System tests.
HP DiagTools is not designed to handle hot swapping. If you
hot swap any components while HP DiagTools is running, you
must restart DiagTools and perform a new Configuration
Detection.
36
readme
readme
file to look for the most recent
Updating Firmware
file of release