Installing The San Switch As A Stand-Alone Unit - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the SAN Switch as a Stand-alone Unit

Use the following procedures to set up the switch as a stand-alone unit. The
following items are required for this setup:
1. Place the SAN Switch 2/16 or on a flat, sturdy surface like a table or lab
2. Apply the rubber feet as follows.
3. Connect the power cable to the SAN Switch 2/16 power supply and to a power
4. Turn on the power to the switch (flip the AC switch to 1). The switch
5. If the SAN Switch 2/16 includes a second power supply, repeat steps 3
Note:
instructions on how to set the IP address, see
page 39.
SAN Switch 2/16 Version 3.1.2 Installation Guide
SAN Switch 2/16
AC power cords and cables supplied with the switch
Rubber mounting feet supplied with the switch
bench.
a. Clean the four depressions that are at each corner of the bottom of the
switch to ensure they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against the
chassis, and press into place.
Caution: HP recommends that you install the rubber feet on the switch to help
prevent the switch from accidentally sliding off the table or bench.
outlet. Ensure the power cable is routed so that it is not exposed to stress.
automatically runs a Power-On Self-Test (POST).
through 4 for the second power supply.
Do not connect the switch to the network until the IP address is correctly set. For
Installing the SAN Switch 2/16
"Configuring Network Addressing" on
25