Configuring The Ip And Fibre Channel Address; Displaying Devices Within The Fabric - HP StorageWorks 2/16 - SAN Switch Installation Manual

Configuring the IP and Fibre Channel Address

The SAN Switch 2/16 is shipped with a default IP address of 10.77.77.77.
Use these steps to change the default IP address and configure the Fibre Channel
IP address of the switch.
1. Log in to the switch as the admin user.
2. At the command line, issue the ipAddrSet command.
3. At the Ethernet IP Address prompt, enter the new IP address for the
4. At the Ethernet Subnetmask prompt, enter the address of the
5. At the Fibre Channel IP address prompt, enter the Fibre Channel IP
6. At the Fibre Channel Subnetmask prompt, enter the address of the
7. At the Gateway Address prompt, enter the IP address of the gateway
8. You are then prompted either to make the IP address changes active now or at

Displaying Devices within the Fabric

To verify that you have fabric-wide connectivity when you install a new switch,
display the fabric-wide device count from the newly installed switch. Use these
steps to display the fabric.
1. Log in to the switch as the admin user.
2. At the command line, issue the nsAllShow command.
SAN Switch 2/16 Version 3.1.2 Installation Guide
An interactive session opens and you are prompted for configuration values.
Press Enter to skip a prompt and leave the parameter value as is.
Ethernet port on the switch. Press the Enter to continue.
subnetmask, if applicable. Press Enter to continue.
address for the switch. Press Enter to continue.
subnetmask, if applicable. Press Enter to continue.
system if applicable. Press Enter to continue.
The configuration is then committed to the switch firmware.
the next reboot. Enter y at the prompt to have the IP address changes take
effect immediately.
This command displays all the connected devices in the fabric.
Managing the SAN Switch 2/16
63