Installing The Switch As A Stand-Alone Device - HP StorageWorks 8/24 - SAN Switch Hardware Reference Manual

Installing the switch as a stand-alone device

To install the switch as a stand-alone unit:
1.
Unpack the switch, and verify that all items listed in
present.
2. Locate the four rubber feet in the accessory box.
3. Apply the adhesive rubber feet to the switch. The rubber feet help prevent the switch from sliding
off the supporting surface:
a. Clean the indentations at each corner of the bottom of the switch, to ensure that they are free of
dust or other debris that might lessen the adhesion of the feet.
b. With the adhesive side against the chassis, place one rubber foot in each indentation, and
press into place.
4. Place the switch on a flat, sturdy surface.
5.
Apply power to the switch as described in
"Powering the 8/8 or 8/24 SAN Switch on and
"Powering the 8/40 or 8/80 SAN Switch on and
CAUTION:
Do not connect the switch to the network until the IP address is set. See
"Shipping carton contents" on page 25 are
off" on page 47 or
off" on page 47.
"Set the IP
8Gb SAN Switch hardware reference manual
address" on page 42.
29