Package Contents; Installing The Switch As A Stand-Alone Unit - HP StorageWorks 8B - FC Entry Switch Reference Manual

2
Installing and Configuring the Switch

Package Contents

The major items included in the shipping carton(s) include the following items:
•
•
•
•
•
•
•
•

Installing the Switch as a Stand-Alone Unit

This section provides instructions for setting up the switch as a stand-alone unit on a flat surface.
The following items are required:
•
•
•
To set up the switch as a stand-alone unit:
1. Check contents of the shipping carton to verify all the required parts and hardware are
available.
2. Apply the rubber feet by completing the following steps:
CAUTION
from accidentally sliding off the supporting surface.
a.
b.
3. Place the switch with the bottom side down on a flat, sturdy surface.
2-2
One FC Entry Switch 8B or FC Switch 8B
One 10 ft. RS-232 serial cable (convertible to an RJ-45 connector by removing the adapter
on the end of the cable)
One grounded 6 ft. power cord
Rubber mounting feet (used only for setting up the switch as a stand-alone unit)
Two rails and one bag of rail mounting hardware (required if the switch is to be installed
in a rack)
One plenum
HP Surestore FC 1Gb/2Gb Entry Switch 8B and FC 1Gb/2Gb Switch 8B Getting Started
Guide
HP Surestore FC 1Gb/2Gb Entry Switch 8B and FC 1Gb/2Gb Switch 8B Documentation
CD
FC Entry Switch 8B or FC Switch 8B
Power cord
Rubber mounting feet
Installing the rubber feet on the switch is recommended to help prevent the switch
Clean the four depressions on each bottom corner of the switch to ensure they are free of
dust.
Place a rubber foot in each depression with the adhesive side against the chassis and press
into place.
Installation and Reference Guide