Power Requirements; Electrostatic Discharge Precautions - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the SAN Switch 2/16

Power Requirements

Two AC power cords connect to the switch on either side of the rear panel. The
AC power source must have the following:
The switch has a universal power supply capable of functioning worldwide
without voltage jumpers or switches. The power supply is auto ranging in terms of
accommodating input voltages and line frequencies.

Electrostatic Discharge Precautions

To prevent electrostatic damage, observe the following precautions:
24
A properly wired, earth-grounded AC outlet
Voltage capability of 85–264 VAC
Input voltage frequency of 47–63 Hz
Power capability of 75 watts, maximum
Avoid hand contact by transporting and storing products in static-safe
containers.
Keep electrostatic-sensitive parts in their containers until they arrive at
static-free workstations.
Place parts on a grounded surface before removing them from their
containers.
Avoid touching pins, leads, or circuitry.
Always make sure you are properly grounded when touching a static-sensitive
component or assembly.
SAN Switch 2/16 Version 3.1.2 Installation Guide