HP Xw4400 - Workstation - 2 GB RAM Reference Manual page 137

Table 5-18 POST error messages (continued)
Screen message
411—Network Interface Card
Interrupt Conflict
501—Display Adapter Failure
510—Splash Screen image
corrupted
511—CPU, CPUA, or CPUB
Fan not detected
512—Chassis, rear chassis, or
front chassis fan not detected
514—CPU or Chassis Fan not
detected
601—Diskette Controller Error Diskette controller circuitry or diskette
605—Diskette Drive Type
Error
610—External Storage Device
Failure
611—Primary Diskette Port
Address Assignment Conflict
912—Computer Cover Has
Been Removed Since Last
System Start Up
914—Hood Lock Coil is not
Connected
916—Power Button Not
Connected
ENWW
Probable cause
IRQ address conflicts with another
device.
Graphics display controller.
Splash Screen image has errors.
Fan is not connected or might have
malfunctioned.
Fan is not connected, might have
malfunctioned.
CPU fan is not connected or might
have malfunctioned.
drive circuitry incorrect.
Mismatch in drive type.
External tape drive not connected.
Configuration error.
N/A
Hood lock mechanism is missing or not
connected.
The power button is not connected.
Recommended action
Reset the IRQ.
1. Reseat the graphics card (if applicable).
2. Clear CMOS.
3. Verify that the monitor is attached and turned on.
Install latest version of SoftPaq to restore image.
1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
1. Reseat the chassis, rear chassis, or front chassis
fan cable.
2. Reseat the chassis, rear chassis, or front
chassis fan.
3. Replace the chassis, rear chassis, or front
chassis fan.
1. Reseat the CPU or chassis fan.
2. Replace the CPU or chassis fan.
1. Run Computer Setup (F10 Setup).
2. Verify and replace cables.
3. Clear CMOS.
4. Replace diskette drive.
5. Replace the system board.
1. Run Computer Setup (F10 Setup).
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear CMOS.
Reinstall tape drive or press
reconfigure without the drive.
1. Run Computer Setup (F10 Setup).
2. Remove expansion cards.
3. Clear CMOS.
No action required.
1. Reconnect or replace hood locking mechanism.
2. Reseat or replace hood locking mechanism cable.
Connect power button.
POST and error messages 127
F1 and allow system to