Screws; Special Handling Of Components - HP Xw4400 - Workstation - 2 GB RAM Reference Manual

Screws

The screws used in the workstation are not interchangeable. They might have standard or metric threads
and might be of different lengths. If an incorrect screw is used during the reassembly process, it can
damage the unit. HP strongly recommends that all screws removed during disassembly be kept with
the removed part, and then returned to their proper locations.
NOTE: Metric screws have a black finish. American National (unified) screws have a silver finish.
NOTE: As each subassembly is removed from the workstation, place the subassembly away from the
work area to prevent damage.
If necessary, additional drive guide screws are provided on the system chassis. There are eight Metric
screws (1) located on the chassis near the 5.25-inch optical drive bays. These screws can be used to
mount additional optical drives or an optional diskette drive. There are four American National screws
(2) located on the chassis near the hard drive. These screws can be used to mount additional hard
drives in the 3.5" hard drive cage.
NOTE: The Metric (black) and American National (silver) screws are not interchangeable.
Figure 4-1
1
2

Special handling of components

The following components require special handling when servicing the workstation.
WARNING!
Lifting the workstation from the front bezel or lifting it incorrectly could cause the unit to fall and cause
harm to the user and damage to the workstation. To properly and safely lift the workstation, lift it from
the bottom of the unit from either the desktop or minitower configuration.
ENWW
Metric and American National screw identification
Metric screws
American National screws
Do not use the front bezel as a handle or lifting point when lifting or moving the workstation.
Service considerations 55