HP Xw4400 - Workstation - 2 GB RAM Reference Manual page 104

2. Place the hard drive in the bracket (1) and secure with American National screws (2) as shown in
the following illustration.
Figure 4-51
3. Screw four screws to the bracket (1). Align the screws with the grooves in the optical drive bay and
slide the drive in (2) the chassis.
Figure 4-52
4. Connect the data cable to the hard drive (1) and to the system board (2). SATA installation is shown.
94 Chapter 4 Removal and replacement procedures
Installing hard drive into bracket
Installing hard drive into optical drive bay
ENWW