HP Xw4400 - Workstation - 2 GB RAM Reference Manual page 38

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading Option
Default Setup
Apply Defaults
and Exit
Ignore Changes
and Exit
Save Changes
and Exit
Storage Device
Configuration
Storage Options
28 Chapter 3 System management
Description
Restores system configuration from a diskette.
Save Current Settings as Default
Saves the current settings as default settings for the next operation.
Restore Factory Settings as Default
Restores the factory settings as the default settings for the next operation.
Restores factory default settings, which includes clearing any established passwords.
Exits Computer Setup without applying or saving any changes.
Saves changes to system configuration and exits Computer Setup.
Lists all installed non-SCSI storage devices (except SATA devices) and provides options for getting
specific information about each device.
NOTE: SCSI storage drives will not be listed in Computer Setup (F10).
Hard Disk
Provides information about the hard disk drives in the system.
CD-ROM
Provides information about the CD-ROM drives in the system.
Diskette Type (for legacy diskette drives only) Identifies the highest capacity media type accepted
by the diskette drive. Options are 3.5" 1.44 MB, 5.25" 1.2 MB, and Not Installed.
Default Values
Resets devices to their default configuration.
Multisector Transfers Options are 8, 16, and Disable.
Transfer Mode Specifies the active data transfer mode. Options (subject to device capabilities) are
Max UDMA, PIO 0, Max PIO, Enhanced DMA, and Ultra DMA0
A new Automatic option has been added to allow for BIOS to automatically determine the
translation mode used to configure a previously formatted SATA or USB mass storage device. This
prevents you from having to know how the mass storage device was previously formatted.
Ordinarily, the translation mode selected automatically by the BIOS should not be changed. If the
selected translation mode is not compatible with the translation mode that was active when the
disk was partitioned and formatted, the data on the disk will be inaccessible.
Translation Mode Options are Automatic, Bit Shift, LBA Assisted, Use (Cylinders, Heads, Sectors),
and Off.
Removable Media Boot
Enables/disables ability to boot the system from removable media.
ENWW