Installing An Optional Optical Drive - HP d325 ST Hardware Reference Manual

Installing an Optional Optical Drive

To install an optional optical drive:
1. Remove the optical drive if present.
2. Install two guide screws in the lower holes on each side of the drive.
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can
damage the internal components of the drive.
When replacing the drive, transfer the four screws from the old drive to the new one.
The screws take the place of drive rails.
Installing Guide Screws in the Optical Drive
Hardware Reference Guide
Hardware Upgrades
2-23