Installing A Hard Drive In The Removable Hard Drive Cage (Bays 1 - 3) - HP Compaq SP700 Reference Manual

Installing a Hard Drive in the Removable Hard
Drive Cage (Bays 1 - 3)
The removable hard drive cage is capable of being configured with up to three
1.0-inch hard drives or with two 1.6-inch hard drives. Other than using different
screw holes, the installation for both drives is basically the same.
To install a 1.0-inch hard drive in the removable hard drive cage:
NOTE: Prior to installing a SCSI device, please read "SCSI Cables and
Guidelines" later in this chapter.
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel and the removable hard drive cage.
3. Remove four hard drive screws (top group of screws) from the side of
the air plenum located at the front of the workstation.
4. Locate the correct screw holes for the hard drive you will be installing.
Compaq Professional Workstation SP700 Reference Guide
8-13