HP Xw4400 - Workstation - 2 GB RAM Reference Manual page 94

4. After pulling the drive (1) out, remove the four guide screws (2) from the drive. Only remove the
four guide screws if you plan to install another drive.
Figure 4-34
To install an optical drive:
1. Disconnect power from the system
access panel
on page
2. Insert the four guide screws (1) into the drive.
3. Align the screws with the grooves in the drive bay and gently slide 2 the drive into the unit until it
snaps into place.
CAUTION:
disengaged. Failure to do so can cause damage to the drive when moving the workstation.
84 Chapter 4 Removal and replacement procedures
Removing the optical drive screws
(Side access panel on page
63).
Ensure that the optical drive is secure by pulling to see if the drive can become easily
(Predisassembly procedures on page
62) and remove the front bezel
57), remove the side
(Front Bezel
ENWW