Crosshair Cursor Size; Save 4014 Graphics Display; Set Tek Graphics Height; Set Tek Graphics Width - Neoware T5730 - Compaq Thin Client User Manual

Crosshair Cursor
Size
Save 4014
Graphics Display
Set Tek Graphics
Height
Set Tek Graphics
Width
Registry Entry: CrosshairSize = 1-1024
Command Line: -X1-1024
Default Setting: 1024
Only applicable to TeemTalk versions that support graphics
emulations.
This specifies the size of the graphics cursor, where size is a numeric
value in the range 1 to 1024, i.e. world coordinates.
Registry Entry: SaveTekImage = "on"
Command Line: -P
Default Setting: off
Only applicable to TeemTalk versions that support graphics
emulations.
This specifies that the 4014 graphics display is saved when you
switch to alpha mode so that it is restored when you switch back to
graphics mode.
Registry Entry: GraphicsHeight = <integer>
Command Line: -GH<integer>
Default Setting: Not applicable
Only applicable to TeemTalk versions that support graphics
emulations.
This specifies the height of the Tek graphics area in pixels.
Registry Entry: GraphicsWidth = <integer>
Command Line: -GW<integer>
Default Setting: Not applicable
Only applicable to TeemTalk versions that support graphics
emulations.
This specifies the width of the Tek graphics area in pixels.
Initialization Commands
Display Settings 443