Device Modes - Neoware T5730 - Compaq Thin Client User Manual

HP 700-92/96 Emulation

Device Modes

288 Function Keys & Buttons
The cursor will move to the leftmost column on the next line when
the current line has been printed. You can cancel printing at the end
of the current line by pressing Return.
Note: If the cursor is positioned on a line below the last displayable
line of data, nothing will be sent to the printer.
Copy Line - F8
When a printer is connected and enabled by the
clicking this button or pressing F8 will cause a copy of the line con-
taining the cursor to be sent to the printer. The cursor will move to
the leftmost column on the next line when the line has been printed.
Note: If the cursor is positioned on a line below the last display-
able line of data, nothing will be sent to the printer. If the cursor is
positioned on an empty line between two blocks of data, the printer
will perform a carriage return and line feed.
This set of functions is asserted by pressing the F9 key (equivalent
to the User System key) then F1 and F1 again.
Device Control - F1
Clicking this button or pressing F1 will cause the
functions to be asserted. These enable you to select the device(s) to
which data is sent and also to copy portions of data from display
memory to the printer. The buttons and keys F1 through F8 will
function as described in the section "Device Control" on page 286.
Record Mode - F2
This is used to copy data received from the host to the printer and/or
display, depending on the setting of the
Device Control
labels in the
To Ext Dev
To Ext Dev
menu.
function,
Device Control
To Display
and