The General Tab - Neoware T5730 - Compaq Thin Client User Manual

The General Tab

Start Seq
The box enables you to enter the character or sequence of
characters that initiate a print bypass.
The end sequence that terminates the print bypass can be specified
either by entering the actual characters in the
Specify End Sequence
characters that make up the end sequence in the
End on Non-Hex
when
End Seq
If no is entered, the bypass is assumed to be for a single pair
of characters only. If an
stream between the start and end are interpreted as encoded ASCII.
For example, "1B0A" becomes ASCII 27 10 (ESC LF).
End on Non-Hex
Selecting
characters that make up the end sequence in the
The bypass will then terminate as soon as a non-hexadecimal char-
acter is received (any character except in the range 0 through 9 and
A through F) followed by the end sequence.
Characters can be entered in several ways. For example, to specify
the ASCII escape character, you can enter either _027, \u001B, \e,
\033, or even ^[.
is checked, or by specifying the number of
is checked.
End Seq
is specified, characters in the data
enables you to specify the number of
IBM 3270 Settings
Setup Menus
End Seq
box when
End Length
box
End Length
box.
175