Table of Contents
Advertisement
Setup Menus
Transmit Terminator
Factory default: ETX
This specifies the last character that is sent to indicate the end of a
block transmission. The character can be ETX, EOT or CR.
The Display Tab
Partition 0
Factory default: Message Row
The display is divided into two partitions numbered 0 and 1. Parti-
tion 0 is a single line that can be used to display status reports and
messages either at the bottom or top of the display, as determined by
the setting of the Message Row option. Partition 1 is a page of 24
lines. The setting of this option determines whether Partition 0 is
Blank or used as a Message Row.
Message Row
Factory default: At Row 25
The setting of this option determines whether the message row
(Partition 0) is at the top or bottom of the display.
Blink Displayed As
Factory default: Caret
In VIP mode the start of a flashing field can be indicated by a caret
or space character.
BQ 3107 Settings
205
Advertisement
Table of Contents
