Installing The Auxiliary Legs; Checking The Loop Cutting - Brother BAS-705 Instruction Manual

2-4.Installing the auxiliary legs

q
w
u
i

2-5. Checking the loop cutting

q
w
1. Remove the two auxiliary legs w which are secured
2. Re-install the two removed legs w as shown in the
3. Loosen the nuts u (in two places) and turn the level
NOTE: After adjusting, securely tighten the nut u.
t
r
e
y
NOTE: At the time of shipment from the factory, the V-
No 1
1. Remove the q, set the knife stopper w to the posi-
2. Check that DIP switch No.1-2 on the panel is set to
5
to leg frame q.
illustration at left, and secure them with the bolts e,
spring washers r and flat washers t which were
removed before.
adjusters i to adjust the height of the casters y
above the floor.
cutting cylinder is in the lock position (flat-end
cutting).
Changing to V-shaped cutting
tion shown in the illustration at left, and then re-tighten
the bolt q.
"ON".
2. PREPARATION
BAS-705