Winding Bobbin Thread - Brother BAS-705 Instruction Manual

4. SEWING

4-3 Winding bobbin thread

Do not touch or place anything against any of the moving parts while winding the lower thread,
otherwise personal injury or damage to the machine may result.
y
r
i
u
w
q
t
e
A
B
CAUTION
1. Turn on the power switch.
2. Place the bobbin q onto the bobbin winder shaft w.
3. Wind the thread around the bobbin q several times
in the direction indicated by the arrow.
4. Push down the bobbin presser arm e.
NOTE If the thread cannot be wound on evenly, adjust
by following the procedure described below.
To wind more thread onto the bobbin q, loosen
the screw r and move the bobbin presser arm
e to adjust the thread winding amount.
5. Once winding of the bobbin thread is completed,
remove the bobbin q from the bobbin winder shaft
w and trim the thread using the thread trimmer t.
If the circuit protector y has been activated,
NOTE
the bobbin winder motor will not operate. Wait
1 minute for the machine to cool down, and
then pres the protector y.
(If the machine has not cooled down
sufficiently, the protector will pop back up
again.)
If you make the bobbin winding tensio stronger
than necessary, it may cause problems during
sewing.
If the thread winds onto the bobbin unevenly
If the thread winds onto the bobbin unevenly, loosen
the nut u and turn the bobbin winder thread tension
stud i to adjust.
* If the thread winds on as shown in A, turn the bobbin
winder thread tension stud i clockwise; if it winds
on as shown in B, turn the bobbin winder thread
tension stud i counterclockwise.
26
BAS-705