Adjusting The Air Pressure For Cleaning Away Belt Scraps (During V Cutting); Adjusting The Looseness Of The Belt Loops - Brother BAS-705 Instruction Manual

6-3-5. Adjusting the air pressure for cleaning away belt scraps (during V cutting)

6-4. Adjusting the looseness of the belt loops

increases
decreases
q
e
6. STANDARD ADJUSTMENT (MECHANISMS)
* Adjust the air pressure using the air adjusting
lever.If it is parallel to the air tubes, the air pressure
will be greatest, and if it is turned either way from
this position, the air pressure will become less.
* Make the air pressure strong enough so that the
belt loop joints are disposed of properly.
1. Loosen the two bolts w of the loop hold plate q ,
and then move the loop hold plate q in the direc-
w
tion of the arrows to adjust the looseness.
* If the loop hold plate is raised ... looseness increases
* If the loop hold plate is lowered ... looseness de
creases
2. After adjusting, tighten the two bolts w of the loop
hold plate q .
NOTE: Install so that the contact surface of the belt
loops e is parallel to the surface which lays
the belt loops e onto the loop presser.
61
BAS-705