Adjustments Required When The Belt Loop Width Is Changed; Adjusting Channel; Adjusting The Width Adjustment Plate - Brother BAS-705 Instruction Manual

6. STANDARD ADJUSTMENT (MECHANISMS)

6-2. Adjustments required when the belt loop width is changed

6-2-1. Adjusting channel

e
center line
center line
w
r

6-2-2. Adjusting the width adjustment plate

r
w
r
q
belt loop
coupler
9mm from center line
10mm from center line
8mm from center line
7mm from center line
6mm from center line
5mm from center line
e
loop width
adjustment plate
t
q
w
1. Loosen the two bolts q up to 7 mm, and remove the
channel assembly from the unit.
NOTE: Fine adjustment of channel B (left side) w
should be carried out while the channel as
sembly is attached.
2. Loosen the four screws e and align the channel to
the width of the belt loop.
(Example)
How to align if the belt loop width is 14 mm
(a) Align the perpendicular surface of channel F
(right side) r with a line 7 mm from the cente
line.
(b) Set the position of channel B (left side) w so
that the belt loop joints pass through smoothly.
NOTE: If the center of the V cut is misaligned, move
channel F (right side) r horizontally.
3. Position the coupler of the channel to the coupler of
the unit base. Secure them using the bolt q.
1. With loop presser B q and loop presser F w both in
the raised position, loosen the clamp lever e.
2. Turn the bolt r so that the left edge of channel F t
is aligned with the edges of loop presser B q and
loop presser F w.
3. Tighten the clamp lever e.
NOTE: If the belt loops run along the right edge of
channel B, align the edges of loop presser
B q and loop presser F w the end of the
belt loops.
52
BAS-705