Adjustments Required When The Belt Loop Thickness Is Changed; Adjusting Joint Sensor; Adjusting Loop Support T - Brother BAS-705 Instruction Manual

6-3. Adjustments required when the belt loop thickness is changed

Carry out the following adjustment if the thickness of the belt loops has been changed.

6-3-1. Adjusting joint sensor

Joint sensor
2+0.5mm
Actuator

6-3-2. Adjusting loop support T

Loop sensor
e
w
2+0.5mm
q
Belt loop
When belt loop
is not present
When joint
is present
w
q
belt loops
0.5mm
6. STANDARD ADJUSTMENT (MECHANISMS)
1. Turn the power on.
2. Loosen the bolt q.
3. Adjust the dimension between the center of the joint
sensor and actuator edge to 2
adjusting shaft w.
NOTE: Check that the joint sensor detects the belt loop
joint. When the joint sensor detects the belt
loop joint, the SEAM JOINT indicator lights.
4. Adjust the dimension between the center of the loop
sensor and actuator edge to 2
bolt e.
NOTE1: Check that the loop sensor functions properly
when the belt loop is not set. When the loop
sensor detects that the belt loop is not set, the
LOOP EMPTY indicator lights.
NOTE2: If the belt loop is thin, adjust the dimension so
that it is smaller than 2
1. If belt loops with no curls are being fed during step
operation, adjust so that the clearance between loop
support T q and the belt loops is approximately 0.5
mm.
2. Loosen the screw w and move loop support T q in
the direction of the arrow to adjust.
55
0.5 mm using the
0.5 mm using the
0.5 mm.
BAS-705