Adjusting The Fork Shaft And The Belt Loop Transfer Height - Brother BAS-705 Instruction Manual

6. STANDARD ADJUSTMENT (MECHANISMS)

6-3-4. Adjusting the fork shaft and the belt loop transfer height

q
0.5mm 1mm
r
t
y
1. If the 1st bar tacking position and 2nd bar tacking
position are not aligned. Loosen the two bolts q and
then move the fork bracket stopper w to adjust the
position of the fork bracket so that the heights are
the same. After adjusting, tighten the two bolts q.
It is possible to determine whether the fork bracket
is parallel to the top of the needle plate.
w
2. If not enough pressure is applied for the thickness
of the belt loops, loosen the two bolts e and move
loop pressers B r and F t up or down to adjust the
distance between them and button presser A y.
* As a guide, the distance should be 0.5 - 1 mm
e
r
3. Loosen the two bolts t of loop support B y, and
then align loop support B y with the top of loop
presser B w.
coincidence
w
58
less than the thickness of the belt loops.
parallel
BAS-705