Changing The Loop Cutting Shape (V Cut Or Flat Cut); Adjusting The Air Pressure For Cleaning Away Belt Scraps (During V Cutting) - Brother BAS-705 Instruction Manual

6. STANDARD ADJUSTMENT (MECHANISMS)

6-7. Changing the loop cutting shape (V cut or flat cut)

NOTE: Be sure to turn off the power switch and release the air before carrying out this operation.
w
q
q
w

6-7-1. Adjusting the air pressure for cleaning away belt scraps (during V cutting)

Changing to flat cut
1. Remove the bolt q, remove the knife stopper w,
and then change the direction of the knife stopper
No 1
w as shown in the illustration at left. Then install it
again and tighten the bolt q.
2. Set panel DIP switch No. 1-2 to OFF.
Changing to V cut
1. Remove the bolt q, remove the knife stopper w,
No 1 and then change the direction of the knife stopper
w as shown in the illustration at left. Then install it
again and tighten the bolt q.
2. Set panel DIP switch No. 1-2 to ON.
* Adjust the air pressure using the air adjusting lever.
If it is parallel to the air tubes, the air pressure will be
greatest, and if it is turned either way from this posi-
tion, the air pressure will become less.
* Make the air pressure strong enough so that the belt
loop joints are disposed of properly.
64
BAS-705