Adjusting The Tension Of Driving Belt - Brother KE100 Motor Drive User Manual

-'-
o
Adjusting the tension of driving belt
r-
1) Release the safety lock for transportation.
IT]
Loosen the bolt
CD
by turning it 2~3 revolutions. Then while pushing the
plastic plate to the direction of arrow so as not to remove it from the rail,
turn the bolt
®
counterclockwise by 3 revolutions.
[2]
Push both plastic plate and bolt
®,
and fasten the bolt
CD
by the wrench.
~ Turn the bolt
®
clockwise by 2 revolutions.
er""a'O"al bac
wffioch
"'-'+-
Push
Bolt G)
2) Adjust the tension of driving belt.
IT]
Place the shuttle at the center of rail.
Loosen the bolt on the opposit side of the motor head by the wrench until
the belt touches the upper part of the shuttle.
[2] Then turn the bolt clockwise by 3.5 revolutions.
I
Rear view
I
Shuttle
Left end of rail
Wrench
-5-