Table of Contents
Advertisement
ADVANCED OPERATION GUIDE
3
Press [Subject] to
enter an E-mail
subject not more
than 60 characters.
NOTE:
Refer to the Operation Guide for entering characters.
4
Press [OK].
5
Press [Body] to enter an E-mail Body not more than 500 characters.
6
Press [OK].
7
Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the
measurement ranges that can be set.
Input units
Inch models
Metric models
NOTE:
Refer to page 1-27 and page 2-28 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Function Defaults, [ ] and then
[Change] of Border Erase Default.
Common Settings - E-mail Subject/Body
Set the default subject and body.
Subject
Body
Status
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
System Menu
Cancel
OK
10/5/2006
Range
6-29
10:10
Advertisement
Table of Contents
