Network Settings - Kyocera FS-2100DN Operation Manual

Menu
Security
Note When the network settings have been changed, restart the network card of the device. This is mandatory to
make the settings effective. For details, refer to Restart Network (Restarting the network card) on page 4-61.

Network Settings

This section explains the settings for when DHCP is used or when an IP Address is entered while TCP(IPv4) is selected.
For details of the settings, refer to Network (Network settings) on page 4-54. Also, for how to use the Menu Selection
System, refer to Using the Menu Selection System on page 4-7.
Note When entering an IP Address manually, check the IP Address, Subnet Mask and Default Gateway with the
system administrator.
Menu:
1
********************- Report Print
2 USB Memory
3
Counter
Network:
1
********************- TCP/IP Settings
2 Restart Network
Submenu
Network Security WSD-PRINT
Enhanced WSD
EnhancedWSD(SSL)
IPP
SSL Setting
IPSec
Thin Print
LAN Interface
1
a b
[ Exit ]
2
3
a b
[ Exit ]
SSL
IPP over SSL
HTTPS
Off/On
Thin Print over SSL
While the printer displays Ready to print., Please wait. and
Processing., press [Menu]. The mode selection menu is
displayed.
Press  or  to select Network.
Press [OK]. The Network menu screen appears.
2-3
Preparation before Use
Setting
On/Off
On/Off
On/Off
On/Off
Off/On On/Off
Encryption AES/DES/3DES
On/Off
On/Off
On/Off
On/Off
On/Off
Auto/10BASE-Half/
10BASE-Full/
100BASE-Half/
100BASE-Full/
1000BASE-T